Allied Vision Technologies Pike Instrukcja Obsługi Pobierz pdf (Strona 153)

Description of the data path

PIKE Technical Manual V4.0.0

153

How to transfer parameters to the camera

The following 3 variants of transferring the parameters are available with the

firmware 3.x:

In the following you find a short description of each variant:

Encapsulated Update (begin/end)

The Encapsulated Update (begin/end) has the following characteristics:

• Host will set a parameter update begin flag in the camera

• Host will send several parameters to the camera and then signalize end

by resetting the flag

• All parameters will become active for the same next image

• Dependent on timing mode, the camera

– (standard Update): uses the previous parameters until the update

flag is reset

–(Quick Format Change Mode): waits until the update flag is reset.

In the Encapsulated Update (begin/end) the exact sequence is:

1. Parameter update begin (advanced feature register)

2. Standard IIDC register update (1..N register) (standard feature register)

3. Parameter update end (advanced feature register)

Transfer mode

Advantage ☺ Disadvantage 

Encapsulated Update (begin/

end)

☺ easy to use (standard quad

writes in camera register is

possible)

 one write access per register

access

Parameter-List Update ☺ only one write access for all

parameters

☺ fastest hostcamera transfer

(from 5 parameters on faster

than encapsulated mode)

☺ handling of parameter list

easy

 not so easy to use (block

writes)

 max. 64 entries for parameter

list

Standard Update (IIDC) ☺ compliant with IIDC V1.31  non deterministic change of

parameters

Table 54: Comparison of 3 transfer modes

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 331 332

Komentarze do niniejszej Instrukcji

Brak uwag

Allied Vision Technologies Pike Instrukcja Obsługi Strona 153

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Aparaty z pseudo lustrem Allied Vision Technologies Pike